Audi R8 2007 Manuel du propriétaire Page 100

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 210
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 99
HomeLink98
Press and hold down the two outer buttons until the indi-
cator diode starts to flash page 95, fig. 80.
Then release the buttons.
After the programming of the HomeLink® universal transmitter
buttons has been erased, the system will return to the training
mode and is ready to be re-programmed at any time.
Note
Programmed buttons cannot be erased individually.
For security reasons it is advisable to erase the programming of
the HomeLink buttons prior to selling your vehicle.
Applies to vehicles: with HomeLink
Reprogramming a HomeLink® button
A HomeLink button can be re-programmed individually
without affecting the other button allocations.
At the operating unit
Press and hold down the selected HomeLink® button
until the indicator diode page 95, fig. 80 starts flashing
slowly.
At the front bumper
–Hold the original hand-held transmitter for the garage
door opener or other device close to the front bumper
directly below the right headlight page 96, fig. 81. The
exact distance depends on the system that you want to
program.
Press the button on the original hand-held transmitter
for the garage door opener or other device.
As you do so, watch the turn signals on your vehicle.
HomeLink confirms successful programming by flashing
all four turn signals three times.
If the turn signals fail to flash three times, repeat the
procedure with the transmitter held at a different
distance from the bumper.
When the turn signals have flashed three times, this means the
device previously stored in HomeLink has been erased and the new
system programmed in its place. To activate the new system, press
the HomeLink button that has just been re-programmed.
Note
It may require several attempts before programming is successful.
When programming a new device, keep the button pressed for at
least 15 seconds before trying again with the transmitter in a
different position. Keep watching the turn signals during that
time.
Applies to vehicles: with HomeLink
Conformity certification
The HomeLink universal transmitter is registered in the following
countries under the following certification numbers:
Country Certification number
Andorra 16SEP2003
Belgium RTT/D/X2064
Denmark 98.3142-266
Germany D800038K
Finland FI98080106
France 97619 RD
document_0900452a816e6cc9.book Seite 98 Mittwoch, 21. Februar 2007 1:32 13
Vue de la page 99
1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 209 210

Commentaires sur ces manuels

Pas de commentaire