Audi R8 2007 Manuel du propriétaire télécharger pdf (Page 13)

Instruments and warning/indicator lamps 11

Controls Safety Driving tips General maintenance Self-help Technical data

Rev counter

The rev counter indicates the number of engine revolu-

tions per minute.

You should select a lower gear if the engine speed drops below

1500 rpm. The start of the red zone on the dial indicates the

maximum engine speed which may be used briefly when the engine

is warm and after it has been run in properly. However, it is advisable

to change up a gear or lift your foot off the accelerator (or shift out

of the R tronic sport mode) before the needle reaches the red zone.

Caution

Never allow the rev counter needle ⇒ page 10, fig. 2 to go into

the red zone on the scale for more than a very brief period: there is

a risk of damaging the engine. The start of the red zone on the dial

is different for some engine versions.

Radio-controlled clock

When the clock is in “radio-control” mode the signal recep-

tion symbol (a radio tower with radio waves) appears in the

display ⇒ fig. 3. It is then not possible to change the

minutes or the date manually. If you take your vehicle into a

different time zone, the hour display will need to be

adjusted manually to local time using the adjuster button.

Setting the time zone

– Keep pulling the button ⇒ fig. 3 briefly until the time

zone display flashes (select setting “0” if you do not wish

to change the time zone).

– Then turn the button to the left (to set an earlier time

zone: -1/-2) or to the right (to set a later time zone: +1/+2).

Switching date display on and off

– Keep pulling the button briefly until the date display

flashes.

– Then turn the button to the left or right.

When the display stops flashing, this means the setting you are

performing is completed and the time zone has been successfully

stored.

If the clock does not receive a radio signal for three consecutive

days, it will automatically switch to “quartz” mode. The signal recep-

tion symbol will then disappear. If you need to reset the time and

date, proceed as described on ⇒ page 12.

Fig. 3 Detail of the

instrument cluster:

Display with signal

reception symbol, time

and date

document_0900452a816e6cc9.book Seite 11 Mittwoch, 21. Februar 2007 1:32 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 209 210

Commentaires sur ces manuels

Pas de commentaire

Audi R8 2007 Manuel du propriétaire Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Audi R8 2007