Audi R8 2007 Manuel du propriétaire Page 187

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 210
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 186
Self-help 185
Controls Safety Driving tips General maintenance Self-help Technical data
Tightening wheel bolts
Fit the box spanner as far as it will go over the wheel
bolt
5)
.
Grip the box spanner as close to the end as possible and
tighten the bolt firmly by turning clockwise.
Have the tightening torque of the wheel bolts checked as soon as
possible with a torque wrench. The correct tightening torque is
120 Nm.
The inflation pressure must be checked as soon as possible.
Put the tools and jack back in the luggage compartment.
WARNING
The wheel bolts must not be loosened – this would cause a safety
risk.
Note
Do not use the hexagonal socket in the screwdriver handle to
loosen or tighten the wheel bolts.
If you notice that the wheel bolts are corroded and difficult to
turn, they must be replaced before having the tightening torque
checked.
In the interest of safety, drive at moderate speeds until the tight-
ening torque of the wheel bolts has been checked.
Jump-starting
Before starting the engine
If necessary, the engine can be started by connecting it to
the battery of another vehicle.
If the engine should ever fail to start because of a discharged
battery, the battery can be connected to the battery of another
vehicle to start the engine. Suitable jump leads are required.
Both batteries must be rated at 12 Volts. The capacity (Ah) of the
booster battery should not be significantly lower than that of the
discharged battery.
Jump leads
The jump leads must be heavy enough to carry the starter current.
Refer to the details given by the manufacturer.
Only use jump leads with insulated battery clamps.
Positive cable – usually red
Negative cable – usually black
WARNING
When it is discharged the battery can freeze at temperatures
around 0°C. A frozen battery must first be thawed out before
connecting the jump leads, as it could otherwise explode.
Please note the safety warnings referring to working in the
engine compartment page 155.
Note
There must be no contact between the two vehicles as otherwise
current could flow as soon as the positive terminals are connected.
The discharged battery must be properly connected to the
vehicle's electrical system.
5)
An adapter is required to tighten the anti-theft wheel bolts page 182.
document_0900452a816e6cc9.book Seite 185 Mittwoch, 21. Februar 2007 1:32 13
Vue de la page 186
1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 209 210

Commentaires sur ces manuels

Pas de commentaire